1 UBEC 1AT AUTO TANK Fill System 08899155 & 08899156 Installation, Operation, & Setup Instructions
10 Control Valve Installation instructions for the control valve can be found in the Unibody Valve and Controller Manual (Document P/N 98311000). Aft
11 CALIBRATION The TankVision has unique calibration programs that enable it to be used on tanks of all shapes and sizes. Note: The standard pressur
12 CALIBRATION STEPS Non-Linear Calibration This non-linear calibration procedure can be used for any shape or size tank. The calibration process req
13 1. Fill the tank. (Do not fill up into the fill tower) 2. Apply power to the Display Module. 3. Swipe the magnet five (5) times to enter calibr
14 OPERATING INSTRUCTIONS The AUTO TANK system is designed to automatically maintain the water volume in the tank of a pumper. It is more specificall
15 During all modes of operation the TankVision display functions normally and the volume of water in the tank is shown on the 9 LED display. All
16 Result: The system is put into automatic mode, the green LED comes on, and the valve closes. 5. Drain water from the tank. Result: The display sh
17 SPECIFICATIONS System Requirements Tank Size: o Min 500 Gallons o Max No Maximum (Less than 10 vertical feet tall) Total Discharge f
18 WIRING Figure 5: Display Module Wiring Diagram Supplied Harness (P/N 37069000) Supplied Harness (
19 Figure 6: Conrtol Module Wiring Diagram
2 TABLE OF CONTENTS PRODUCT SAFETY INFORMATION 3 MONITOR CALLOUT DRAWING 4 OVERVIEW 5 INSTALLATION INSTRUCTIONS 7 TankVision Display Module 7
ELKHART BRASS 1302 WEST BEARDSLEY AVE P.O. BOX 1127 ELKHART, IN 46514 PHONE: 574-295-8330 • 800-346-0250 FAX: 574-293-9914
3 PRODUCT SAFETY INFORMATION All personnel who may be expected to operate this equipment must be thoroughly trained in its safe and proper use.
4 SYSTEM CALLOUT Figure 1: AUTO TANK System Display & Control Modules
5 OVERVIEW The AUTO TANK System is designed to work with around-the-pump foam systems where there is a need to fill the water tank and maintain low p
6 Pressure Sensor The pressure sensor is mounted on a side of the tank near the bottom. It provides a signal that is proportional to the volume of li
7 INSTALLATION INSTRUCTIONS TankVision Display Module Note: It is recommended to mount the display at eye level for accurate tank level readings. 1.
8 AUTO TANK Control Module 1. Measure and mark mounting location for cutout and mounting screw holes. Make sure there is clearance for the module an
9 Pressure Sensor The pressure sensor is mounted on one of the tank sides approximately 2 inches from the bottom. The pressure sensor can only be uti
Comments to this Manuals