Elkhart-brass Cobra EXM Quick Install Guide User Manual download pdf





















Step 1. Mount Monitor onto base

Step 2. Attach Nozzle to Monitor

Step 3. Confirm Connections

Install monitor to flange using 5/8”-11

UNC Grade 5 bolts and nuts. Tighten

uniformly (20 lb increments) to 60-70ft/lb

using Loctite 242 or equivalent.

MOUNT MONITOR - FLANGE

P/N 98491100 Rev C

Thread monitor onto base using Loctite

592 thread sealant or equivalent.

Tighten using strap wrench on hex

portion of monitor base.

MOUNT MONITOR - THREADED

Install a 20A fuse (12VDC) into the

positive power lead; 10A fuse for 24VDC.

SUPPLY POWER - FUSE

Position monitor discharge elbow parallel

to the ground. Ensure gasket is inside

nozzle swivel before installing.

Confirm that all connections are tight and all electrical connections have been reconnected. If installing additional

components, such as controllers, you may choose to double check the connections after everything has been installed.

POSITION DISCHARGE

Hand tighten nozzle to monitor using

swivel. Position actuator assembly about

90° as shown above.

POSITION NOZZLE ACTUATOR

Tighten swivel using a spanner wrench to

ensure a secure connection.

TIGHTEN NOZZLE

Connect nozzle & monitor two-way

connectors.

CONNECT POWER

Quick Install Guide

COBRA EXM

16g

Gasket or

Sealant

90°

0°

90°

1 2 3 4

Summary of Contents

Page 1 - COBRA EXM



Page 2

Step 4. RF InstallationPanel Mount ControllerHandheld Controller / Docking StationJoystick Controller OEM Interface Module Position Feedback DisplayIN

Page 3 - Step 7. Operational Settings

CALIBRATE HORIZONTALENTER/EXIT SETUP MODECALIBRATE VALVEOn the Handheld, press and hold FOG & STREAM buttons for 5 sec. (AUX & PRESET on Joyst

Page 4 - Button Press Logic

NOTE: You can manually control nozzle position while in a single axis oscillation (Ex: Up/Down in Horz., and Left/Right in Vert.). Any direction in a

Comments to this Manuals

No comments

Elkhart-brass Cobra EXM Quick Install Guide User Manual

Browse online or download User Manual for Equipment Elkhart-brass Cobra EXM Quick Install Guide. Elkhart Brass Cobra EXM Quick Install Guide User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Equipment Elkhart-brass Cobra EXM Quick Install Guide